期刊： INDIAN GEOTECHNICAL JOURNAL, 2021; 51 (4)
Climate change altered variations in weather trends and rainfall fluctuations could trigger soil slope instability, causing landslides or debris flows......
期刊： INDIAN GEOTECHNICAL JOURNAL, 2021; 51 (3)
The recycling and reuse of construction waste in landfill covers help reduce environmental pollution and promote sustainability. Further enhancement o......
期刊： INDIAN GEOTECHNICAL JOURNAL, 2021; 51 (4)
Granite residual soil, which is formed by weathering of granite, is widely distributed in southern China. Previous studies have shown that granite res......
期刊： INDIAN GEOTECHNICAL JOURNAL, 2021; 51 (4)
The locust has been devastating pest, which destructs the crops and pastures. Scientists discover the breeding habitats of locust based on soil surfac......
期刊： INDIAN GEOTECHNICAL JOURNAL, ; ()
The research on penetration mechanism of jacked pile has been the focus of pile engineering. However, the majority of literature was limited in scope ......
期刊： INDIAN GEOTECHNICAL JOURNAL, ; ()
To examine the changes in the permeability and the microstructure of the gravel layer under different overburden stresses, samples of leachate are tak......
期刊： INDIAN GEOTECHNICAL JOURNAL, ; ()
To explore the water resistance properties of lime soil ground, the physical and mechanical properties of lime soil with 5%, 10%, 15% and 20% lime con......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (1)
Recently, three-dimensional (3D) printing technologies have been widely applied in industry and our daily lives. The term 3D bioprinting has been coin......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (1)
Poly-l-lactic acid (PLLA) possesses good biocompatibility and bioabsorbability as scaffold material, while slow degradation rate limits its applicatio......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (1)
Fe is regarded as a promising bone implant material due to inherent degradability and high mechanical strength, but its degradation rate is too slow t......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (1)
The skin is the largest human organ, and defects in the skin with a diameter greater than 4 cm do not heal without treatment. Allogeneic skin transpla......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (1)
An additive manufacturing technology based on projection light, digital light processing (DLP), three-dimensional (3D) printing, has been widely appli......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (2)
This study explored the potential of three-dimensional printing (3DP) technology in producing a three-dimensional (3D) medication label for blind and ......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (2)
Hypertrophic scars (HS) are considered to be the greatest unmet challenge in wound and burn rehabilitation. The most common treatment for HS is pressu......
期刊： INTERNATIONAL JOURNAL OF BIOPRINTING, 2020; 6 (2)
Composite hydrogels have gained great attention as three-dimensional (3D) printing biomaterials because of their enhanced intrinsic mechanical strengt......
